U-Line SS1095 Przewodnik Instalacji

www.U-LineService.comPhone (414) 354-0300 • FAX (414) 354-7905Service & Parts Tech Lines Phone (800) 779-2547 • FAX (414) 354-5696OnlineService@U-

www.U-LineService.com 10 09/2008SS1095MARINE SERIESChecking Door AlignmentThe unit’s door is aligned at the factory before shipment. However, its alig

09/2008 11 www.U-LineService.comSS1095MARINE SERIES3. Locate the compression fitting and ferrule packed with the unit. Slide the compression fitting a

www.U-LineService.com 12 09/2008SS1095MARINE SERIESLeveling InformationIMPORTANTIt is extremely important that the unit sits on a level surface, as it

09/2008 13 www.U-LineService.comSS1095MARINE SERIESInstallation TroubleshootingProblemQ:Water is leaking under the unit.SolutionA:A water leak under t

www.U-LineService.com 14 09/2008SS1095MARINE SERIESStart-Up TroubleshootingProblemQ:Unit does not appear to turn on when plugged in. SolutionA:Make su

09/2008 15 www.U-LineService.comSS1095MARINE SERIESThis page intentionally left blank.

©2008 U-Line CorporationPublication No. 30222E09/2008 Rev. AU-Line Corporation, located in Milwaukee, WI, is a family operated manufacturer of built-i

www.U-LineService.com 2 09/2008SS1095MARINE SERIESContentsFollow Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . 2Safety Alert Defin

09/2008 3 www.U-LineService.comSS1095MARINE SERIESGeneral PrecautionsUse this appliance for its intended purpose only and follow these general precaut

www.U-LineService.com 4 09/2008SS1095MARINE SERIESYour U-Line product has been designed for either free-standing or built-in installation. When built-

09/2008 5 www.U-LineService.comSS1095MARINE SERIESModel SS1095FD: Follow the cut-out drawing in (Figure 3). The unit must sit in a frame structure wit

www.U-LineService.com 6 09/2008SS1095MARINE SERIESProduct DimensionsDoor Swing/Clearances InformationModel SS1095NF:Units have a zero clearance for th

09/2008 7 www.U-LineService.comSS1095MARINE SERIESReversing the DoorDepending upon the location of the unit, it may be desirable to change the side on

www.U-LineService.com 8 09/2008SS1095MARINE SERIES8. Using a Phillips screwdriver, remove the two screws holding the custom stainless handle from the

09/2008 9 www.U-LineService.comSS1095MARINE SERIES14. Place the door latch assembly on opposite side of unit (Figure 17). Be sure to tighten all three