U-Line CLR2160 Instrukcja Naprawy Pobierz pdf (Strona 11)

CLR2160, CLRCO2175 11

Maintenance

Proper maintenance of your U-Line product will ensure

efficiency, top performance and long life. The

maintenance intervals listed are based on normal

conditions. You may want to shorten the intervals if you

have pets or other special considerations.

Defrosting

Automatic (Cycle) Defrost and Frost-Free Models

These models do not produce frost in normal operating

conditions. However, a frost pattern may be noticed on

the interior walls if the unit is repeatedly opened in a high

heat or high humidity location. If this frost pattern does

not clear within 24 hours, your unit will require manual

defrosting.

WARNING

DO NOT use any type of electrical heating device,

ice pick, knife or other sharp instrument to

defrost; this could damage the inner lining or

refrigeration system and void the warranty.

IMPORTANTIMPORTANT

The drain pan was not designed to capture the

water created when manually defrosting. To

prevent water from overflowing the drain pan,

place towels or other absorbent materials over the

interior drain trough, under the evaporator (Figure

7, 1), before defrosting.

Figure 7

To defrost:

1. Turn unit off.

2. Remove all products from the interior and prop the

door in an open position (2 in. (5 cm) minimum).

3. Allow the frost to completely melt naturally. Clean the

interior and all removed components using a mild non-

abrasive detergent and warm water solution applied

with a soft sponge or non-abrasive cloth.

NOTE:

NOT use any solvent-based or abrasive cleaners. They

will discolor or damage the interior.

4. Dampen a soft sponge or non-abrasive cloth in clean

water and wipe down the cabinet interior and removed

components to remove any detergent residue. Rinse the

sponge or cloth in clean water and repeat as necessary

until the cabinet and components are clean.

5. When the interior is dry, turn unit back on.

Condenser Cleaning

Interval - Every Three Months

To maintain operational efficiency, keep the front grille

free of dust and lint and clean the condenser every three

months. Depending on environmental conditions, more

or less frequent cleaning may be necessary.

WARNING

Disconnect electric power to the unit before

cleaning the condenser.

To remove and replace the grille for access to the

condenser fins, follow this procedure:

Figure 8

1. Disconnect electrical power to the unit.

2. Loosen two screws

(Figure 8, 1)

completely.

NOTE: Screws are held in the grille by o-ring retainers,

and will not come free of the grille.

3. Remove the grille.

WARNING

DO NOT touch the condenser fins. The condenser

fins are SHARP and can be easily damaged.

ULIN_0185_A

ULIN_0203_A

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Komentarze do niniejszej Instrukcji

Brak uwag

U-Line CLR2160 Instrukcja Naprawy Strona 11

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Lodówki U-Line CLR2160